xoltri's Discussions (5)

Sort by

More problems.

Grasping at straws at this point.  Had an actually good flight, did my first loiter and RTL failsafe that went well.  Was getting more confident and decided to try out the vertical performance of my quad, and then this happened (0:46 and 1:00 in the

Read more…

Pixhawk causing motor sync issues.

I believe I have a problem with my Pixhawk and was hoping for some help.  Also posted this on rcgroups.

The issue is that when my speed controllers are hooked up to the Pixhawk they exhibit a bad sync issue.  However when they are connected to my old

Read more…

Pixhawk only likes to flip and crash.

I have had exactly 0 successful flights with Pixhawk so far.  This quad flew fine on APM other than the fact that my clone APM had a bad barometer, which is why I switched to pixhawk.

My quad is about 1.5kg AUW, SimonK 30A esc's with Afro NFET V2014-0

Read more…

Pixhawk vs APM power module.

Is there any difference between the Pixhawk and APM power modules?  I originally had an APM with the power module and have recently upgraded to the Pixhawk.  The power module is buried in the quad and it would be tough to swap it out for the one that

Read more…

BarAlt on a clone APM 2.6.

I have an ebay clone APM 2.6.  Recently I had a crash and after going through my other logs I noticed that my take off altitude is always 0, but even though I land in the same place my landing alt is 5 or 10 higher.  Is there something wrong with thi

Read more…