Photos

4-Rotor UAV 2nd Generation Platform

Posted by Rod Gatehouse on May 3, 2009 at 11:12am

4 x Alpha 480 (1020kv) Brushless Motors from NitroPlanes

4 x 30A Electronic Brushless ESC Speed Controller [Volcano Series] from NitroPlanes

2 x 11.1V 2200mAh 20C 3 Cell High Performance Lithium Polymer Battery from NitroPlanes

2 x APC 10x4.7 SFP Slow Flyer Counter Rotating Prop Pair from Dragonfly

1 x Carbon fiber tube frame (0.75" ID x 0.825" OD x 60") from Carbon Fiber Tube Shop

3/4" PVC Irrigation fittings

Read more…
Previous
Tags: 4-rotor, quadcopter, uav
E-mail me when people leave their comments –
Follow

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • Rod Gatehouse July 31, 2009 at 4:18pm
    Gian,

    I haven't added up the cost of the parts, it's not unreasonable as I am using relatively low cost ESCs and brushless motors. NitroPlanes is a good source for these. In any case, it's an experimental platform for software development, so cost has not been a primary consideration so far.
  • Gian Carlo M. July 29, 2009 at 9:29pm
    Final cost?
This reply was deleted.