Mrija 1

Mrija 1

Read more…
E-mail me when people leave their comments –

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • Doh, the wind blows a little stronger than that around here
  • Sorry, been out for a while.
    It took almost a year and a half.
    Currently redesigning the wings with new profile.
    Thank you for the appreciation, Wyliest
    WHILE.IT
  • How much work dos it take to make this plane? looks great!!!
  • No parts from other planes.
    Wings are cut from styrofoam, covered with balsa sheets and oracover white film.
    Fuselage is made of glass fiber out of a custom mold.
    Mold itself was built around a foam mockup.
    V tail are two balsa strips covered with oracover.
    Booms are obtained from two arrows.
    Motor is an AXI 2820 with an 60 amps controller.
    Batteries are 4 x 3000 mAh LiFePo4.
    No "intelligence" on board, for the moment.
  • 3D Robotics
    All custom foam cutting, or did you reuse some parts from other planes?
  • PS thank you for the appreciation
  • Not bad, after all. At first attempt it didn't take off at all, so I increased wing incidence.
    Then I flew it only for some minutes: stall speed is slow and it's fairly manouverable, for one that has few piloting experience like me
  • 3D Robotics
    Great design--how does it fly?
This reply was deleted.