Hey Latin105fm.
The rendering above is a mixture of two planes, the wheel retract, the winglets and the airbrakes comes from a Ventus and might very well be a good idea. However as my Aero-Master took a dive into terra firma, due to a lockup in the elevator.
So now I use an EasyGlider for photo and film and presently I'm working on a High wing Beaver from Staufenbiel in Germany.
Best regards Poul.
Hey Chris. Your right as far as I know it's only available as Ready-to-cover, I quote "Wings are of built up construction with full balsa sheeting, lightweight and strong. Ailerons are pre-cut in the outer wing panels as is the location for the aileron servo. Outer and inner wing panels must be glued, a carbon joiner is provided. Wings slip onto steel joiner rods and are removable for easier transport and storage. Stabilizer and elevator are attached to the fin by screws and are removable." end quote. I bought it from Hobby Lobby so it took some time and patieance before I had it on my doorstep. I put an AXI 2826/10 in it. A 3s 4270 mAh lipo is my power sorce. I'm not shure what my sorce will be when I go UAV or FPV. It's pretty fast as is now.
Best regards
Poul.
Comments
The rendering above is a mixture of two planes, the wheel retract, the winglets and the airbrakes comes from a Ventus and might very well be a good idea. However as my Aero-Master took a dive into terra firma, due to a lockup in the elevator.
So now I use an EasyGlider for photo and film and presently I'm working on a High wing Beaver from Staufenbiel in Germany.
Best regards Poul.
I am building an Aero-Master too, here is my future project :)
Best regards
Poul.