You could add small oval holes to side of Arm bar. mounting hole is 5mm from end of bar. side hole start's at 10mm - 25mm have round ends and it's 6 mm at height. If looking that arm on right/low conder, then you would see this oval cable exit hole inside frame area.
Comments
And thank you for your solidwork files. If you have any questions, please do not hesitate to contact :P
Thanks for the kind words. I'm bit of a newbie when it comes to R/C so I'm really excited to see how Arducopter project pans out.
I agree with ken regarding the powder coating, it could add too much unwanted weight.
What kind of materials are planned for each of the parts? Plastic/Wood/Carbon Fibre??
BTW, I'll post some links to the solidwork files later on tonight.
I might even include it especially if we get big enough runs to diecasting company. Yes it will add some extra cost but that should not be too much.
You could add small oval holes to side of Arm bar. mounting hole is 5mm from end of bar. side hole start's at 10mm - 25mm have round ends and it's 6 mm at height. If looking that arm on right/low conder, then you would see this oval cable exit hole inside frame area.
--jp