Combined 900MHz RC Tx and data modem, plugs into buddy cord from Tx and USB to laptop for GCS. Eliminates the 72MHz or 2.4GHZ receiver and transmitter.

Read more…
E-mail me when people leave their comments –

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • Really great job done, Greg !, Its amazing !, Hats off to you for such a nice accomplishment !
    What is the performance of this system ? I mean there are many many data types being transmitted by the airborne plane to the ground station and you have limited data throughput, how you have managed ?
  • David, I use a dipole for now, for long range I'll use a yagi. The Digi 900MHz modem is a 1 watt tranceiver, 40 mile LOS range at 9600 baud, shorter at 115.2K baud.
  • Good point Jack, the cable is a pain. Why didn't I think of that? Again the KISS principal reins. I'll make the changes to the next round of hardware redesigns.
  • Tethering a transmitter to a data modem? Always wondered why the pros did that when they could just take the original RC receiver & tether it to the data modem. The cost of a bunch of servo cables would be covered by the freedom to roam & not have to support different buddy box protocols.
  • thx greg~
    what antenna u used in ur gcs?
    dipole or patch or yagi?
    i am using dipole antenna for my 2.4ghz xbee modem(ground and plane) but their performance is bit disappointing.
  • hi greg,
    any idea where to get 900mhz high gain antenna?
    thx
This reply was deleted.