Photos

Droidworx CX-4

Posted by DaveyWaveyBunsenBurner on January 27, 2012 at 5:54am

Droidworx CX-4 frame

DJI Wookong Controller

4x Axi heavey lift motors

4 x hooby wing ESCs (soon to be upgraded)

Graupner 5x11 E props (too small)

Read more…
Previous
Next
E-mail me when people leave their comments –
Follow

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • DaveyWaveyBunsenBurner February 13, 2012 at 4:29pm
    Hi Lebdog

    A ball nosed allen key slipped in there just nice!

    I think 12inch props would be a bit more efficient but she flies real nice as she is so will probable leave it as it is. She climbs like a rocket on full juice!
  • Lebdog February 11, 2012 at 3:22pm

    Very Nice, just combing through the photo section.  I like the gun metal!
    Did you have to do something  special to tighten the motor mounts to the arm mount?
     In the case of my AVROTO motors, basically the same motors, I couldn't get at the allen head to tighten it, so I just went by hand.  I will use needle nose with rubber tips to make sure it's secure..  
    So you think a 12" prop is the way to go too??   

This reply was deleted.