I started out with a simple 250 racing drone about 8 months ago, but could not figure out why 2 of the 2300 KVA motors were not starting to spin as the other 2. So I went for a bigger frame and decided to assemble a 450 DJI Flame wheel fitted with 1000KVA motors and the same control board that I had on the 250. However after re-flashing the Naze32 with Clean flight I have the same problem with one of the motors this time as it does not start spinning as the other 3 motors. I don't know where the problem is coming from and would appreciate if someone might give me some advice. Thanks
Comments
I started out with a simple 250 racing drone about 8 months ago, but could not figure out why 2 of the 2300 KVA motors were not starting to spin as the other 2. So I went for a bigger frame and decided to assemble a 450 DJI Flame wheel fitted with 1000KVA motors and the same control board that I had on the 250. However after re-flashing the Naze32 with Clean flight I have the same problem with one of the motors this time as it does not start spinning as the other 3 motors. I don't know where the problem is coming from and would appreciate if someone might give me some advice. Thanks
The DJI Flame Wheel 450 is an excellent quad for learning. It can take a licking and keeps on ticking. Not so much for the clones though.