Photos

Posted by John Galczynski on May 22, 2011 at 11:59am

Not fastened just yet... Calibration and angle testing platform.

diy - roll- pitch- yaw board test platform, angle, board, calibration, diy, dynamic, measurement, measuring, motion, testing

E-mail me when people leave their comments –

You need to be a member of diydrones to add comments!

John Galczynski May 22, 2011 at 7:36pm

Regarding the 3-axis test Roll turns close to axis - about a one inch radius from center line of roll axis. Pitch (up-down) turns are approximately five inches from the center line. Yaw (heading - degrees) are on center line of the vertical axis of the above test platform. This angle measurement tool was built to test UAV hardware gyros and magnetometers.

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.