OCTOV travelling stability with 2.0.42

So today i tried to make a movie with the GoPro and the OCTOV platform and it seems to be stable.

Next step is to put caoutchouc under the motors to absorb more vibration.

This Plateform is really dedicaded for movie !! enjoy Guys !!

Views: 532

Comment by Grizouille on October 2, 2011 at 11:01am

Nice !!! It would be necessary in FPV !!!

Manque plus que le FPV et tu pourrais faire une belle vidéo !!

Comment by Gerard Valade on October 2, 2011 at 1:53pm

Nice stability

Comment by FPVGenie on October 3, 2011 at 4:39am

Thats cool. There is something I have always been puzzled about, is that the arms on OctaV are 14 degrees off to each side. Now what is the thing with this particular angle ? Why not 10 or 20 degrees ?

There must be a reason / calculation behind this, and that is what I am after.

Thanks ! 

Comment by patrice.rance on October 3, 2011 at 8:44am

yes next step FPV :)

 

Comment by patrice.rance on October 3, 2011 at 8:45am

The code take into account this 14 degrees but i'm sure you can change it !

Comment by FPVGenie on October 3, 2011 at 10:15am

Cool. I am building one. What were your measurements ? 

My arms going to be a meter long. Where did you balance the CG ? I was thinking it should be on the centerline and middle of the arms ? 

 

Comment by patrice.rance on October 3, 2011 at 8:16pm

All branch are 1 meter long. Don't care about the CG ! if you respect the DIY Drawing.

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service