A friend had an accident, how much more you have to tell people to remove the props when uploading a new firmware.
Dude saying it was a "software error" on Multiwii...
and this is the result:
You need to be a member of diydrones to add comments!
A friend had an accident, how much more you have to tell people to remove the props when uploading a new firmware.
Dude saying it was a "software error" on Multiwii...
and this is the result:
You need to be a member of diydrones to add comments!
Comments
Need "THROTTLE HOLD" for multi-copter!!!!!!
I can think of a more dangerous habit.
Frederic, that's a great idea. I think someting similar could be done for quads. Just a simple, single loop that slips over the blade and arm.
Lessons learned : activate pull-up resistor on the arduino, let my feet on the frame until everything is ready.
I have been so worry about this same issue that I made up some prop rotation blocker using duct tape on my Octo Coax that I slip on every time after flying.
This works great with the coaxial config but not on a quad, it will be great to have some piece of hardware that block the motor rotation when we work on our helis.
Like a U shaped staple that we could drop on any prop and that will lock onto the arm.
I hope your friend recovers quickly.
How'd it get both of your hands?
-
1
-
2
of 2 Next