Blogs

Robotic Hand Project # 1

Posted by Joshua Johnson on October 21, 2013 at 12:35pm


What type GCS should I use?! AndroPilot? Mission Planner? Also are their any others compatible with the APM 2.5? If anyone knows of a list of Compatible software for the APM 2.5 please share it with me.  I want to run it to my APM 2.5 if you couldn't already tell! ;)

3689555408?profile=original

 

Joshua Johnson - Diy Drones News

Tags: #, 1, diydronesnews, diy, drone, drones, hand, news, project, robot
E-mail me when people leave their comments –
Follow

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • The Sun October 24, 2013 at 8:42am
    I dont think there is a more needlessly expensive controller method.

    I mean you could put wings on it.
  • Lew Payne October 23, 2013 at 6:50am

    If you put wings on it, thus turning it into a flying hand, you could use ArduPilot and any compatible GCS.

  • Joshua Johnson October 22, 2013 at 1:20am

    Can you comment some links to some useful information and reputable dealers?

    Much Appreciated,

    Joshua Johnson - Diy Drones News

  • Will Hodgson October 21, 2013 at 6:15pm

    If I were doing something like this I probably wouldn't use an apm or ground control station software. I would stick with an arduino and arduino IDE. Arduino's are a lot cheaper than apm's and people have written software to interface them with the connect.

This reply was deleted.