Comments

• 

  nz.mike.christiansen August 5, 2015 at 8:35pm

  Does anyone know what FET is on the IRIS ESC? I have one motor down, looks like 2 FET's up in smoke :( This comes after I soldered a motor lead to the board, I think there may have been excessive heat causing a short maybe. Reading the case I can see Ior p3226 HTZ6_ F8736 but I cannot find this mosfet anywhere? 

  Thanks,

  
• OVIDIO BRACAMONTE July 25, 2015 at 7:58pm

  Hi, Any help to trigger Canon s100 using pixhawk with distance, I try and see all videos and Can't trigger. I am using a usb cable solder to Efla cable.

  thanks for your help
• damir June 19, 2015 at 3:31pm

  Thank you Phelps!
• Jim Phelps June 18, 2015 at 8:52pm

  Damir,

  You want to check that the LED in leg is still working before you put it all together again.  When an arm is broken it can stress the LED cable.  If it needs replacing, you want to do that when you are replacing the arm.  It definitely requires soldering skills.  You can buy new LEDs at SUPERBRIGHTLEDS.COM.
• damir June 18, 2015 at 9:14am

  okay thank you! 
• damir June 18, 2015 at 7:31am

  i broke the  blue arm on the Iris + i have gotten a replacement and i new to this so i was looking for some kind of video or document to explain how i replace the Arm. would anybody know where i can find this information. also i did an firmware and did the re-calibration the Compass and for some reason the Iris + still keep flying in circles! any help would be appreciate!

  thank you! 

   
• 

  Gregg June 14, 2015 at 6:04pm

  Air in  and air out..as finicky as the pixhawk is already is, I would not want to make it over heat!! 
• 

  David Tipping June 11, 2015 at 3:01am

  2 big holes on the top cover above the battery compartment either side of the red button now filled. I blocked these off on the front only using plastic from a disposable food box and leaving vents on either side. I also added another status light making it rather bug like. Have been flying this for a while and no tempissues so far. See attached image :-) 

  David
• 

  UAS_Pilot May 28, 2015 at 3:24pm

  Has anyone had issues with props making noise and loseing lift when yawing?
• 

  David Tipping May 20, 2015 at 11:24am

  So why 2 big holes on the top cover above the battery compartment, either side of the red button.They are OK and could be used for routing cables etc. but spoil an otherwise nicely designed unit. Is there a reason i shouldn't fill them in?

  David