Comments

• 

  Rodney Johnson April 22, 2015 at 4:33am

  :)
• 

  Rodney Johnson April 17, 2015 at 7:10am

  Tom just sent you a friend's request with my email addy,
• 

  Rodney Johnson April 16, 2015 at 8:29pm

  Tom

  If it would help I have a 3DR N6 for one of my pixhawks that I'm not using at the moment and I could send it to you for testing and you could send it back when your finished. It's only a couple bucks to send it USPS instead of getting a new GPS and find that it's the pixhawk. Let me know and I can get it to you.

   
• 

  Rodney Johnson April 16, 2015 at 5:33pm

  Tom

  Do you have the original 3DR Neo6 Gps or another unit so you can try that in place of the 8?

  Where did you purchase the 8? I purchased the 8 that Hobbyking just started selling and it was plug and play getting 18 Sats in less then a Min.
• 

  Richard Kennedy April 16, 2015 at 5:02pm

  @Tom I really would doubt it's the pixhawk as it's just telling you what the gps is saying. Do you have another gps to try? But it sounds like a bad gps to me. 
• 

  Richard Kennedy April 16, 2015 at 4:17pm

  @Tom

  That is certainly not normal in most area's. I would be highly suspect of the gps or the connection to the pixhawk. I typically get 10-12 sats in under 3 minutes. In flight it goes to 16 or more. Very concistant too.  Unplug the wires to the pix and re-secure and see if it's better. 
• 

  djtrickee April 16, 2015 at 8:45am

  @Thomas J Coyle III,

  Hey thanks friend! I admit sometimes I am not a smart man, lol. I was pulling my hairs out, I appreciate the help. Sometimes it takes the clarity of a outsider to point out the obvious. Works perfectly, thanks for the assist.
• 

  Paul Meier April 16, 2015 at 8:44am

  and that receiver side you are connecting the sbus plug

  I have same settings (but 8 CH) and its working...
• 

  djtrickee April 16, 2015 at 8:34am

  Good day,

  Having a problem, I'm getting no power on the RCIN port to my X8R receiver.

  
  I am working on getting my hex finished up and upon hooking up my receiver (X8R) to the RCIN on my Pixkhawk it is not getting powered up.
  Gear:
  4S battery
  3DR PDB
  Frsky X8R receiver (D16 mode) *tried 2 different ones
  Taranis radio
  All cables are hooked up to the Pixhawk including button, buzzer, etc.
  Both the green lights for power are on solid on the top of the Pixhawk also.
  Everything I have read states that the RCIN should be providing power to the receiver correct?
  I have my ESCs attached to the MAIN out 1-6 with signal and ground only. *Also tried having motor 1 ESC with signal, power, and ground and no difference.
  Any ideas what I could be missing or what is going on with that? Do I need to be powering my X8R receiver via a 5V ubec or something?
• 

  Larry A Amati April 16, 2015 at 7:59am

  Emax 40 amp simonk esc's not working with Pixhawk.Works fine connected to x8r receiver. Is there a fix for these? Or, should I look elsewhere for esc's?