Hi Guys. I've searched the forum but am still a little unsure on how to do this. I would like to descend at a faster rate in loiter. Is it the throttle rate in alt hold tuning? If so do I decrease or increase the number?The reason for this is I…
After contacting 3d robotics their only offer was for me to send my apm to them and if they deemed it product faulty then they would either try to fix and send back or send a new unit if they couldn't. Well…"
I have a faulty apm 2.5 that must have a short somewhere between output 1 and 2 as they always fire at the same time.I do not want to wait again for shipped parts if i dont have to...Is there a way to have the software use outputs 3-6 for quad or…
"Well I narrowed it down to the APM. I ran cli motors test with esc's plugged directly into the outputs. No matter what motors are plugged in, 1 and 2 fire together.
I don't know where the short is in it but it's nothing I can see.
Very expensive,…"
"I'm pretty sure I'm on the right software...
Cli motor test...motor 1 (and 2) fire then short pause...motor 4 fires then short pause...motor 2 (and 1) fire then short pause...motor 3 fires then long pause. So it looks like it is running the quad…"
"Ok...found something
When running the cli motor test I realized this time that every time motor 1 would fire, motor 2 would as well and the same when motor 2 would fire, motor 1 would also.
I am going over my apm as my hexa was also flipping.
Can't…"
"OK....this is getting crazy!
Because of a terrible start to this I decided to order quad center plates, 850's, and 10x47's to make things easier.
Built the quad...Went through step by step...and the thing still wants to flip over on take off. I do…"
"3 flights...3 crashes!!!
Turned down stabilize gains...then went for my third flight.
Throttled up slowly but still climbed very fast. Stabilize was much less drastic but still had a slight wobble. Problem was I could not stop it from climbing.…"
"Ok...after now crashing again on my second flight this is getting frustrating.
After first crash I decided to sit down and start again from the power board out.
Reconnected all the esc's, apm, and receiver. Reconfiged the esc's, motor directions,…"
I built my my hexa very slowly after getting a bummed esc. So it gave me lots of time to read all the start up threads including the crash ones.I thought I was thorough going through everything methodically, double, triple checking stuff.Did hand…