Replies

  • m00se July 25, 2012 at 5:53am

    hi

    is that the talon airframe? I have it and i find that the arms rotate after heavy landings, which kills tuning,

    unless there was wind when you were taking off i would say you can improve that drift, mine doesnt have that much, it did have, but it was due to a motor not being very good, i swapped it out and now it works a lot better

  • Alexandre Nascimento July 23, 2012 at 3:40am

    Thanks for all.

    Its flying better.

    I am doing some adjustes manualy during take-off.

  • Helitrasher July 21, 2012 at 10:58am

    I dont think you should expect a automated magical perfect hover machine without some kind of laser guidance, luck and no Ground effect !

  • Patrick Glennon July 21, 2012 at 10:17am

    did you set levels in the mission planner?  That helps drift for me.  I try to do it regularly.

  • Bob Byroad July 21, 2012 at 9:02am

    Looks like it flys well to me. Use those sticks to maintain position and then adjust trims if required. Air movement will always cause them to drift around.

  • 3D Robotics
    Chris Anderson July 21, 2012 at 8:57am

    Make sure all your motors are exactly vertical, too. If need be, just correct it with your sticks and use your trim tabs to make it hover without movement. 

This reply was deleted.