just updated APM to 3.1-rc-4

Posted by mark on October 21, 2013 at 9:52am

Hi,

I just  updated APM to 3.1-rc-4 , did the live calibration and tried to take it out for a simple run and it wont arm. Is there a new arming scheme other than turning the left stick to the far right??

Thanks in advance.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • T3
    Richard Boyhan October 21, 2013 at 6:49pm
    The new code has a failsafe built-in. I've gone ahead and disabled it. You can find it in the advanced parameters. The new failsafe won't allow you to arm unless you do the compassmont have a good compass and GPS lock.
  • Hank Deucker October 21, 2013 at 4:01pm

    I have experienced arming problems with 3.0.1 and found I had to set my throttle trim to the lowest value possible, just a thought

  • David Jackson October 21, 2013 at 10:07am

    I have notice there is not an consisten arming experience. Some time it takes longer then others. I have had best result when I Arm in "Stable Mode". I have also notice that you can not Arm while in RTL.

    I hope this helps

This reply was deleted.