minimosd black screen

Posted by Damo on October 15, 2014 at 4:25pm

Tonight i wired up my 1.1 3dr minimosd. I powered one side via the apm and the other side via the video power as documented. I only get a black screen. There appear to be many people with this issue. Tomorrow i am going to solder the two jumpers and only power via the apm. Am i waisting my time or is the board now fried?

Where in the documentation does it say you MUST power the entire board using the apm as many people seem to suggest?

Any advice appreciated.

Thanks

damo

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Flying Buddha October 16, 2014 at 6:20am

Jumper instructions here: https://code.google.com/p/arducam-osd/wiki/minimosd

I just starting having the same problem. The only thing new, is that upgraded to the latest Arducopter (as of Oct. 10, 2014) on my APM 2.6. If I bypass the minumOSD everything works fine. I have had issues in the past with either the osd displaying or the video only displaying, but that seemed to fix itself when I installed the MinimOSD-Extra.

I have tried these settings (nothing worked):

https://code.google.com/p/minimosd-extra/wiki/APM

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

ArduCopter User Group

Replies