Quadcopter X

Posted by Umut TEKİN on April 20, 2015 at 5:41am

Hi everyone. I am new here. I have apm 2.6 and 3DR quadcopter x. I finished assemblying and setup arducopter programs to apm 2.6 via missionplanner. At last, i connect to battery and give the throttle. At this point quadcopter don't fly, always pull over. Apm 2.6 controller has to control the quadcopter? What am i missing? Sorry for my bad English.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Mamoon Syed April 21, 2015 at 3:23pm

    I had a similar problem once upon a time, make sure your motor connections are correct (pin 1 on APM correspond to motor 1 on quad, etc.)

    • Candy S > Mamoon Syed April 23, 2015 at 8:00pm

      You can follow the manual to fix the motor and propeller, etc. Make sure AMP software is intalled well.

  • Sourlemon11 April 20, 2015 at 9:08am

    Check the wiki. Your props could be in the wrong direction, your esc connections could be reversed, or the esc's are not calibrated.

  • hüseyin yıldız April 20, 2015 at 5:46am

    Merhaba,

    aramıza hoşgeldinizi.,

    sorunuz compass oryantasyonu bence, yani roll 180 degree olabilir. mesala,

    şöyle daha rahat anlarsınız, mission plannerda quadı sağa yönlendirdiğinizde ekrandaki yönelişte aynı yönde olamlı tersi içinde aynı , kontrol edin,

    klon kartlarda başlangıçta bendede aynı sorun olmuştu.

    diğer olası nedenler

    birde propların yani motorların dönüş yönünü kontrol ediniz,

    esclerin throttle gaz kalibrasyonunu yapınız.

This reply was deleted.