Gender
Male
About
Location
Melbourne, FL
About Me:
I like quadcoters
Please tell us a bit about your UAV interest
I am using UAV's for science fair. Easier said then done considering my negligible R/C experience.
Hometown:
Florida
Activity Feed
"And I'm sure we'll be seeing a Kickstarter any day now."
"Prediction number 3 doesn't appear to be very bold at all."
"This is a really interesting design. How is the fuselage made?"
"@Felix, I'm flying octas quite heavily these days, hence my issues with the CAN bus, however I was not aware that it had PM out. Thanks for the info."
"I really REALLY like the look of this board but a seriously prohibiting factor is going to be the premium of CAN integration on the ESC side of things. Even if the board was reasonably priced, I can't see myself spending north of $200 on speed…"
"Guys we need to develop some dead reckoning stat :)"
"This is cool stuff but i'll wait till consumer grade tech comes out."
"Sounds like you have your channels mixed up to me."
"I like the way they implemented battery swapping, but my only qualm is that the drone seems to power down completely during the swap. I think it would be neat if you had an intermediate power source that powered the drone while the battery was being…"
Hello all,My name is Mamoon and I am a high school student down in Florida. I am in charge of my schools little unit of drones which we use for various school event (soccer games, pep rallies etc.) and until now we have been using a GoPro to get our…
"Last day, so I figured I'd give it another shot. Didn't like my old design very much so I figured I'd tone it down a bit (iffy on the whole visibility thing though). This is my second entry, so if that's against the rules, feel free to disqualify…"
"My two cents. May or may not have gone a bit out of hand with the colors, but there ya go."
"Well they took it down :/
Oh well, I guess it means it's close."
Oh well, I guess it means it's close."
Just found this on the Erle Robotics site:http://erlerobot.com/blog/tienda/pxf-bbb/
"That looks really neat! How hard do you think it would be to modify the current gimbal to be a 2 or 3 axis gimbal?
Great job,
-Mamoon"
Great job,
-Mamoon"
Hey guys, I am just getting started at Arducopter, and I bought an Arducopter Rev C from 3DRobotics, but I am having technical difficulties to say the least. I am almost certain there are no soldering errors, and my receiver inputs are in order, but…
