Comments

• 

  Charles lakins March 26, 2013 at 9:08am

  Try going here  http://www.rcgroups.com/video-piloting-fpv-rpv-469/

  there are multiple threads to choose from relating to fpv and on board cameras
• 

  LanMark March 26, 2013 at 7:25am

  John can you start a thread.. which is much easier to contain and get comments from the community.
• John ku March 26, 2013 at 7:07am

  Please pardon me if I've posted my question in the wrong forum.

  I am a complete newbee aspiring to build my very own Tricopter. I would like to mount a camera (GoPro) on board and I suspect I would need a video transmitter and a video receiver if I want to fly FPV (i.e. see where I'm flying). Can someone please explain or point me in the right direction for step by step instructions?

  Many Thanks

  John
• Michael Jensen March 20, 2013 at 2:25pm

  Hexcopter - power question - JP1 jumper - in or out??

  Configuration -

  APM 2.5

  4S 4000 LiPo

  3DR 915MHz radio

  1200 Sonar

  Ext GPS

  Should the jumper be installed or not?

  No camera yet but likely to be a pan/tilt affair with GoPro

  thanks

  mike

  Question
• Charlie Fox February 10, 2013 at 4:48pm

  I find with mine If I'm hovering above say 2m when I click alt hold it rises up a few meters then stops. If under 2m it drops down and lands. Its a bit of an art as it doesn't respond rapidly to throttle input. Definitely not how I expected it to act, i.e. lock at the altitude it was it when I flicked the switch. I think perhaps loiter does though as you can still manouver in loiter,
• 

  Gonçalo Abreu February 10, 2013 at 4:41pm

  Nevermind.. Silly me, i understand ir know. You are implying my throttle stick is not on 40%-60% position?
• 

  Gonçalo Abreu February 10, 2013 at 4:39pm

  I havent quite understood what you've said. Alt hold is not supposed to keep my quad between a sensor offset?
• Charlie Fox February 10, 2013 at 4:15pm

  Hi Goncalo *my keyboard doesn't have that c sorry.
  That is probably normal behaviour.
  
  In ALT hold mode the throttle becomes altitude control. So switching modes doesn't guarantee it will hold its current altitude but rather the altitude relavent to the throttle position.
  
  Gaining or loosing altitude in the mode tends to be quite glacial but switching back out of it can be exciting ;-)
• 

  Gonçalo Abreu February 10, 2013 at 4:09pm

  Quick question for 2.9.1 users. When i toggle altitude hold using inertial navigation my quad slowly drift down(eventually touching the ground). This drift is very slow. What parameter should i look after? Is it possible vibrations are causing this?
• 

  iskess February 10, 2013 at 1:46am

  Please help. I can't get APM to see my LEA-6H. Please see the thread I started here.

  I'm still not clear how to use this forum.