Discussion group for ArduCopter users
Drone flying to non visible point
Hi there,I encountered a problem, while flying in auto mode, with approching to point that was not set by trajectory and is not visible after downloading mission from flight controller by Mission Planner. Does anybody encountered similar problem. The situation is that in the middle flight I stopped the UAV and uploaded new mission and after changing to auto mode it starts to fly in some direction. It goes straight to some point, so I assume it's not mechanical problem. I attached the link to…Read more…
EMPLOYMENT OPPORTUNITIES...... Northeast Georgia
HawkEye UAS is currently accepting applications for it's new UAV Pilot Apprentice Program. The ideal candidates would live in the Gainesville, Georgia area.
FAA Remote Pilot Certification would be a plus, but not required to begin the training process.
Take a look at the job descriptions and see if this is something you would like to grow into. http://www.hawkeyeuas.com/employment-opportunity.html
Send all questions and replies directly to me at: email@example.com
I have a Pixhawk PX4 Flight Controller and I want to use it with the PHANTOM 3 PRO 4K Camera https://hobbyking.com/en_us/phantom-3-accessory-spare-part-4k-camer.... Can you help me to connect this camera to my pixhawk and get it worked.
hello fellow pilots.
Has anyone heard of a aerial mapping system called VMAP?
I have read that tower companies are starting to use drones to inspect and map their towers.
open MP then press control F and the select Param Gen on the left.
close it and MP. Open MP and connect to your APM and all the drop downs in flight mode should now be populated.
Asif what FC do you have? I have an APM 2.8 on my rover and I had the compass jumper in the wrong spot, I had the same issue where I couldn't calibrate the compass.
i have problem with my quadcopter.
it flip as flying. i know i could not calibrate compass in mission planner. mission planner dont get sample when i move my ardupilot
any one can help me?
I think there is a paperclip reset hole on the side of the pixhawk. That should do it.
Is there a simple way to reset my pixhalk ?
I purchased one to put in my 650 tarot and used mission planner to set it up, as I am use to this.
Then I read Qground control was better , don't believe everything you read.
So tryed it and don't like it and thought I could just reinstalled program from mission planner.No you can't won't install firmware ,so I want to start all over again from fresh. Is there a way to do this ? Looked and asked intranet without any joy.
hi, can someone help me with APM 1???