About Me:
I'll tell you later
About
Please tell us a bit about your UAV interest
I am currently building a hex rotor craft based on Tarot 680P frame, with PixHawk 1 flight controller.
I tried PixHawk firmware, and QGroundControl but I switched to ArduCopter 4.0.7 and Mision Planner.
It's all about the reading and configuring the Parameters! I hope to be flying the HexCapitator in the very near future. The name is to remind ME to stay away from those blades!
Hometown:
I'm from Mars
Activity Feed
"As a noob with a PixHawk 2.4.8, I would try using a free serial port first. My familiarity with Arduinos makes me lean toward serial interface.
I understand "companion computers" connect to the USB port, the one located below the TELEM2 port…"
I understand "companion computers" connect to the USB port, the one located below the TELEM2 port…"
"I worked through this on my hexacopter. ArduCopter's numbering of the motors is very specific, not a circle but three diagonals. 1 is the right side, 2 is the left, 3 and 4 are opposite, 5 and 6 are opposite. If you don't have them wired this way…"
"I had this issue with the Ground unit of a 3DR 915 MHz Telemetry Radio pair. I am running MP on Windows 10, and Telemetry RSSI was always zero, even though the LEDs seemed to indicate a radio connection was made. I had to study the chips on the…"
"I'm still very new, but I've been working through the same issue. There are pre-requisites for Arming, in the Flight Controller's firmware. I'd suggest going to Full Parameter Tree in MP and looking at the ARM group of parameters. That may give…"
"Thanks for sharing this photo.
I really enjoy seeing DIY builds, they have opened my eyes to "the possibilities".
I am interested in the props, they seem to have anti-vortex tips.
UAV prop noise can be an issue in public open areas, and…"
I really enjoy seeing DIY builds, they have opened my eyes to "the possibilities".
I am interested in the props, they seem to have anti-vortex tips.
UAV prop noise can be an issue in public open areas, and…"
"Hello, I am a newb both here on DIY Drones and in the world of RC Multicopter UAVs.
I think we can thank all those early hackers/programmers/tinkerers for the wealth of available tech today.
I do agree with the idea of these modern websites…"
I think we can thank all those early hackers/programmers/tinkerers for the wealth of available tech today.
I do agree with the idea of these modern websites…"
