From a regulatory perspective, you want to operate under a thing called the "Low Interference Potential Devices (LIPD) Class License". If you comply with its requirements, you don't need an individual HAM license (which is why it's called a class license.
The link above gives you the settings you need to comply with the license.
You picked a bad time to buy from 3DR, but they might still be able to ship radios. One of the Aussie distributors *might* be willing to do a swap for you.
You're probably better off with the 900MHz if you want to operate legally, but the 433MHz if you're happy to blow through the license-required power.
Long story short 915mhz is fine you do not need a license to use because of the way the telemetry radios operate.
433 can be used without a license BUT you must turn the power right down to 25mW in the settings.
Yeah I think it's just the sheer size and power of the towers themselves. If the receiver and antenna on the tower is sensitive enough you wouldn't need the 3G stick to be all that powerful. Also the towers have many directional high gain antennas spread out to cover the areas around it (or cells).
My Iris arrived and I ordered the 915 thinking that was what I should be using but 3DR sent the 433. What is the advantages of one over the other? Would like to know whether I should get 3DR to send the 915 or keep the 433?
What is involved in getting an amateur radio licence?
Where do I get one from?
How do I know the wattage the radio is outputting?
Actually right now they are just two whip antennas of varying sizes. I do have a large patch antenna I'll be using with an antenna tracker system. Just haven't range tested it yet.
Replies
I can only tell you what works for me:
For video and osd I transmit using this: Video Tx and Video Rx plus the Tx Antenna and a decent Receiving antenna
For the telemetry I don't use their modem instead using a great modem: Better than 3dr modem and that is directly compatible with mission planner.
Hope you'll see the "light" :-)
Read this - especially the bottom
From a regulatory perspective, you want to operate under a thing called the "Low Interference Potential Devices (LIPD) Class License". If you comply with its requirements, you don't need an individual HAM license (which is why it's called a class license.
The link above gives you the settings you need to comply with the license.
You picked a bad time to buy from 3DR, but they might still be able to ship radios. One of the Aussie distributors *might* be willing to do a swap for you.
You're probably better off with the 900MHz if you want to operate legally, but the 433MHz if you're happy to blow through the license-required power.
433MHz
915MHz is 3G
433 can be used without a license BUT you must turn the power right down to 25mW in the settings.
Thanks Dave,
Seems like I have the right one then? From all the answers, it sounds like a confusing subject. Can you confirm that I need a license or not?
No licence for 433MHz but its a very narrow shared band.
No license for 433MHz as long as, your transmission power does not exceed 25mW. Anything beyond that will require a HAM Radio License to operate it.
My Iris arrived and I ordered the 915 thinking that was what I should be using but 3DR sent the 433. What is the advantages of one over the other? Would like to know whether I should get 3DR to send the 915 or keep the 433?
What is involved in getting an amateur radio licence?
Where do I get one from?
How do I know the wattage the radio is outputting?
-
1
-
2
of 2 Next