All Discussions - Gimbal Support

All Discussions (3)

Sort by

gimbal support

Hi, I mounted a 120g camera on a brushless yuntai 2 axis gimbal.

It is mostly balanced. When I turn on the power (5V USB), the pitch axis stabilizes fine, but the roll axis doesn’t. Please see these two videos for explanation:

brushless yuntai 2 axis

Looking for a basic profile for Alexmos32 based Moy 3 axis gimbal

Hi,

looking if someone could share a profile of this gimbal "MOY 3 Axis Brushless Camera Gimbal w/32bit Alexmos Controller Motor for RC bmpcc Sony NEX5/6/7 BMPCC G4 FPV Aerial Photography"

would be much appreciated.

Gal

After updating my Tarot T4-3d and clicking run, the gimbal shaked violently. I have tried calibrating the sensors, and reinstalling the firmware. The gimbal software also shows that the motor channels (pan/tilt/roll) are meching together and are affe

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

Gimbal Support

All Discussions (3)

gimbal support

Looking for a basic profile for Alexmos32 based Moy 3 axis gimbal

Problem updating Tarot T4-3d

Note: this page contains paid content.