Lost connection between Radio and Iris during MP session

Posted by Joe Krolla on May 31, 2014 at 6:36pm

I am not sure what happened, but maybe someone can point me to the error I made:

After upgrading the firmware to 3.1.5 I went through the recalibration process, loaded the Iris with Front GoPro sessings and did the accelerometer calibration. The radio calibration worked fine.

I went to the flight mode settings and wanted to activate the super simple mode for test.

I am not sure whether it was related to this, but when I went back to the radio calibration tab all green bars are gone. The radio is totally unresponsive.

When restarting the Iris, the light blinks blue and stays in that node. 

I cannot get the Iris armed, neither via Radio nor via Ground Station.

The telemetry receiver status light in the Iris is green. I did the repairing twice to ensure it is properly done.. to no avail.

Does anybody have an idea where I made a mistake or where I can start debugging?

Thanks

Joe

Clipboard01.jpg

You need to be a member of diydrones to add comments!

Join diydrones

Tags: radio, blinking, blue, disconnect, unarmed
Email me when people reply –
Follow

Replies

  • Joe Krolla May 31, 2014 at 10:48pm

    I guess you do not. But I did anyway as I reloaded default parameters and I wanted to be on the safe side.

    Re-doing it should not lead to an unresponsive radio.

  • road_rascal May 31, 2014 at 9:34pm

    Are you supposed to go through the recalibration process after installing new firmware?  I didn't when I installed V3.1.4 and I just installed 3.1.5.

This reply was deleted.