Real time extraction of apm 2.5 telemetry to matlab?

Posted by J'Rome on October 5, 2013 at 1:47pm

I would like  to pull the ardupilot telemetry in to matlab, visual studio or visual basic in real time. Specifically, latitude, longititude, altitude and attitude. Any thoughts will be greatly appreciated as its a major stumbling block in my 4th yr project. thx 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Mohamed Abdelkader Zahana August 17, 2016 at 1:46pm

    You can use MATMAV to monitor/control Pixhawk (or Pixracer) from MATLAB, if you are willing to use the PX4 firmware not Arducopter.

    Link

    Introduction · MatMav Guide
  • This reply was deleted.
    • Alireza Manzoori February 17, 2016 at 6:26am

      Hey mikiuse,

      Can you please explain how could you get the ardupilot telemetry data in matlab please?

      Thanks a lot

  • Nate Miller October 7, 2013 at 8:45am

    Check out mavProxy.

  • Shyam Balasubramanian October 5, 2013 at 2:28pm

    Mission Planner already does that. I think you should have a look at its C# code implementation. Follow the setup instruction for Mission Planner source code from (copter.ardupilot.com) and start debugging to know how to..

    Hope this helps!

This reply was deleted.