After installing my Pixhawk 2.1 into my UAV clouds everything was fine up until I had to calibrate my controller to mission planner. Attached is an image of what I am receiving in mission planner. I am using a Taranis X9D Transmitter with a L9R receiver. My receiver is bound and is plugged up properly to my Pixhawk through the RCin port and Sbus port on my L9R receiver. The firmware I have on my Pixhawk is Arduplane 3.8.5(latest version). UAV clouds is a v-tail plane as well and I have setup my inputs into Pixhawk and my radio as needed. I don't know what I could be missing. Power wise I have made sure that the Pixhawk is powered by a battery using the power brick mini so it has plenty of current. Any tips would be greatly appreciated. Thank you.