TAKEOFF WITHOUT USING GPS
Hi,Im working on a autonomous drones and im using JETSON NANO and flight controller PIXHAWK .Im able to control my drone by giving rc commands on the MAVLINK terminal itself by connecting it with PIXHAWK but now i want a python code from which i can do some operations like:takeoff,left ,right,forward,backward…and i am not using GPS…Can anyone please help me…
Read more…
Comments
http://store.rfdesign.com.au/rfd-900p-modem/
Does anyone tried to use Microhard p900 with pixhawk? I am trying to connect but it doesnt connect withQGC
hi all.
have someone can help me to configure the pixy camera to pixhawk?
thank you in advance.
Hi, Can someone help me out with this?
http://diydrones.com/forum/topics/altitude-issues-in-loiter-high-na...
http://discuss.ardupilot.org/t/altitude-issues-in-loiter-high-nav-p...
@javier cerna
tq so much... i'll try it... :)
@ Phil I have that issue with 'plane' I have spent hours trying to get it to read correctly and not give me the warning!!! Drives me nuts!! Please post back if you get it sorted out. thx
Hi Javier
I've calibrated the battery monitor as per your link and it is reading correctly, however it is the constant low battery warning that is the issue. It is sounding when it shouldn't.
@arif
The firmware is compiled using the PX4 Toolchain, from the source code in https://github.com/ArduPilot/ardupilot. Please check the following guide for more information: http://ardupilot.org/dev/docs/building-px4-with-make.html
@Phil Horner
Maybe your battery monitor is not well calibrated. Please check http://ardupilot.org/copter/docs/common-power-module-configuration-.... In particular, you can input the voltage you're reading (23 V).
Hi all
I'm having a problem with the low battery warning function on my Pixhawk. On the HUD screen in Mission Planner, at the bottom where it shows the battery voltage and amps, it is always in red and issuing warnings that the battery is low ie, 21volts. Yet the Voltage is actually reading correctly at 23 volts. Can someone please point me to a link that demonstrates what I can do to fix this issue? I must have altered a parameter at some stage, because it used to work flawlessly.
hello guys..
i new in UAV..
i have project to do with pixhawk and pixy camera. can someone teach me how to edit the firmware or how to see all the coding that been upload in my pixhawk..
hope someone can help me... thank you..