Replies

  • Janis Jonins September 3, 2019 at 11:44pm

    Hi Mike,

    38mm is focal length, this value has to be set in UgCS Mission editor, camera action "Zoom" field.

    Best regards,
    UgCS Support Team
    Janis Jonins

  • Mike Sousa September 3, 2019 at 7:47am

    Hi Janis

    Thanks for the info.

    From the wiki, it states 

    "In UgCS for DJI the value of zoom level is displayed between zoom buttons. This value varies for different DJI cameras according to camera value range. Therefore, before defining the Set camera attitude action value, check the border zoom values of the camera. The Zoom settings of UgCS are limited by optical zoom range of particular camera."

    When controlling the zoom with UgCS for DJI on my Mavic 2 Zoom, I get values of something like, 38mm". What does this map to in the UgCS mission editor?

    Thanks...

  • Janis Jonins September 3, 2019 at 7:19am

    Hi Mike,

    If you are flying simple waypoint mission, camera action is valid till next waypoint with camera action. If you are performing Area scan or Photogrammetry mission, "Action execution" for route has to be set to "Forward passes"

    Camera zoom control is described in UgCS Wiki section: https://wiki.ugcs.com/Actions#Set_camera_attitude_/_zoom

    Best regards,
    UgCS Support Team
    Janis Jonins

    Actions
    Wait action Camera mode attitude zoom Panorama Servo
This reply was deleted.