RTH height.

Posted by Colin Girvan on September 7, 2017 at 12:10pm

We fly a Matrice 600 and we usually start a mission by powering the UAV and checking all parameters in the DJI Go app then switching to the UgCS for DJI to fly the mission. UgCS has a return to home altitude in its route creation screen. There is also an RTH altitude within the DJI Go app. I was wondering which one takes precedence?

Colin.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Victor September 7, 2017 at 2:50pm

    same,in Go- compas calibrate and RTH altitude

  • Eben N. Broadbent September 7, 2017 at 1:58pm
    Same protocol, DJI go also checks firmware, diagnosis for red flashing lights, etc.
  • Colin Girvan September 7, 2017 at 1:50pm

    OK Alexey, I thought that was probably the case but good to have it confirmed.

    The parameters we usually view are all the checks that DJI does under the aircraft status label things like compass, imu, esc status etc.

    Thanks for your help.

    Colin.

  • Alexey Dobrovolskiy September 7, 2017 at 1:41pm

    Colin, could you tell me what parameters are you checking using DJI GO? Camera settings and "ready to fly"? For us is interesting what is missing in UgCS.

  • Alexey Dobrovolskiy September 7, 2017 at 1:38pm

    Hi Colin,

    UgCS updates RTH altitude together with route upload. So if you switch to UgCS for DJI after DJI GO, and next you will upload route - will be used altitude specified in UgCS.

This reply was deleted.