Please tell us a bit about your UAV interest

flying uav helis planes



Activity Feed

A H replied to Richard Ferreeira's discussion tricopter on pixhawk?
"Ill try and point you in right direction, I watched you tube video saying you have to reverse servo in the software not on the radio. So been trying other things thinking is firmware for right frame wiring etc motor direction right . Then I reversed…"
Jul 22, 2015
A H replied to Richard Ferreeira's discussion tricopter on pixhawk?
"Trying to set a tricoptor up with a pixhawk after 4 days still not getting it off the ground has any one a step by step guide, ive googled to try and get a solution but no joy.

It is spinning on its skids when trying to take off yawing to the…"
Jul 19, 2015
A H replied to Michael Monti's discussion Pixhawk/Tri motor setup question.
"Hi there what direction are your motors as ive set mine to all anti clockwise with 3 motor firmware was thinking of putting  3.3-rc5 firmware in but it is spinning like the ruder has been activated
Jul 18, 2015
A H posted a discussion
Any one that could help me to, What frame do I set this to H or X and has any one got the file for there setup on same frame 250 size, also do I set it up as a plane or Helicopter on my dx8picture attached.ThanksTonyPICT0549.JPG
Jun 8, 2015
A H posted a discussion
could I use a 2.4 ghz antenna on a telementry 433mhz sysem
May 29, 2015
A H posted a discussion
flashed firmware using mission planner mini APM v3.1 controller in x quad v3,2,1 but saying board has retired so will flash with this file, so don,t know if it is detecting board properly. saying board is a 36b405fbwould it be best to flash it with…
May 14, 2015