Hi,
During my first experimental flight with:
Tarot X6 960 frame
2x Tattu 10A 6S LiPos
Taranis X9D+ with S3 switch installed
FrSKY X8R
3DR original Pixhawk with Arducopter 3.3
I had an issue switching flight modes (switch setup on S3 multi-position): flying
Read more…Hi guys,
I have a Tarot X6 960 with 3DR Pixhawk FCU.
Until now, I made 3D mapping and orthophoto with a DJI Phantom 3 Professional, post-processing the images in Pix4D.
I would buy a camera to do mainly 3D mapping and orthophoto with the Tarot X6.
I just
Read more…Hi all,
I'm assembling a Tarot X6 with some electronics (LED lights controller, LiDAR, Connex etc.) and I would make the work as clean as possible.
In order to safeguard the parts, I would mount the GPS antenna on the very top of the central chassis (u
Read more…Hi all,
I finished my Tarot X6 960 frame that I will use for experimental purposes.
I need to open the upper plate to shorten some cables and I found that almost all of the M3 screws that go into the spacer are stripped because I used too much thread l
Read more…Hi guys,
I have a strange problem with the motors on my Tarot X6 960 that I am setting up.
Details: Pixhawk Arducopter FW 3.3.3, Taranis X9D+ radio, X8R receiver, setup made with APM Planner on Mac. Question about CH.1 to CH.4 behaviour.
Radio calibrate
Read more…Hello,
what's the easiest way to plan a vertical orbit scan of a wind turbine?
We need to build a 3D model of a turbine for study purposes, we are aware of the orbit mode, but we cannot find an easy way to extend the photogrammetry vertically to cover
Read more…Hello,
Using a M210 RTK, is it possible to add the correction of the base position of DJI RTK differential antenna?
We use a GNSS NMEA base antenna to verify the DJI base error. We would insert this difference in order to save the right data on the EXI
Read more…Hi all,
We are under trial with UgCS and we're looking for a way to plan a vertical survey (like on a facade of a building or a rock cliff).
Is there any ideal procedure to plan it?
Thanks.
Read more…Hello,
I would use the DJI smart batteries (i.e. The ones used with the M600 Pro, TB47S) in order to have higher density batteries and a smart chip to discharge them after x days.
I know these guys from Italy achieved it, don't know if they used APM-li
Read more…Hi all,
Do you have any experience flying with dangerous Kp index (above 5 I would say) WITHOUT using GPS, so in Alt Hold or Stabilize?
Is it safe to fly with strong solar storms if I exclude GPS and possibly magnetometer?
I both use APM or PX4.
Read more…Hello,
I'm doing a research about some of the most important inspection drones.
I can't find detailed informations about the Falcon 8/Falcon 8+. I'm looking for details like which motors it uses, kind of props and ESCs.
Is there anyone who knows more?
Th
Read more…Hi all,
Do you know any smart LiPo manufacturer besides Tattu?
Thanks.
Read more…Hi all,
Do you know any smart LiPo manufacturer besides Tattu?
Thanks.
Read more…Hi all,
Did you have experience with 2-in-1 PCs like the Hp pavilion x2 10-n002nl running reliably MP?
Is it enough with 2 GB of RAM and Windows 10?
Sorry but I'm a Mac user...
Read more…Hello,
I really need your support in order to finish my UAV for survey purposes.
The setup is:
I need to
Read more…Hi,
In order to avoid any risk of flyaway, defective GPS or HW issue during flight, even if I can fly pretty well in Stabilise, is it possible to remote a switch from external M8N to 3DR Pixhawk internal GPS just in case I should need to do this?
Copte
Read more…Hi all,
I'm doing all the necessary experimental flights in order to register it with my aviation authority.
During the hovering duration test (endurance) in loiter mode, I noticed that the relative altitude on APM Planner (Mac) in 30 minutes raised fr
Read more…Hello,
I must power a LCD FullHD TV on field.
Since I cannot use my car's battery to power the monitor, what's the best 12V battery I can use to power the TV plus another couple of devices (like Video RX)?
Do you have any experience with batteries? I al
Read more…