ARM based Arduino
Hi,
Does anyone know when the new ARM based Arduinos will be available? I know the annoucement came last September. I'm really excited about these since they can do native double calculations.
-Adam
Read more…Adam Crain's Discussions (5)
Sort by
APM2 will not power from output rail
My APM2 powers from the input rail with the jumper off, but will not power from the output rail (pin 3 esc) with the jumper on. How do I diagnose this to determine if it's a fault board?
thanks,
Adam
Read more…versions of xplanes and cost?
I'm following the directions on the ArduPlane wiki for getting HIL working with XPlanes. It seems there's a new version of xplanes (v10). They're advertising it for 79$. The wiki claims $29? Any advice on version. I don't see a version other than X-P
Read more…Newbie questions, brand new to APM, Arduplane, and MissionPlanner
Hi all,
I just received an APM 1.0 module from udrones (have a 2.0 on backorder), but am stuck on a certain step of the setup. What I've accomplished so far:
1) Uploaded ardupilot 2.27 alpha from the mission planner
2) Wired up my receiver and a few ser
Read more…Still camera recommendation for aerial survery from UAV
Hi,
I'm looking for a camera recommendation. Here are some requirements:
1) Zoom not required.
2) Good optics and high pixel count for aerial imaging.
3) External triggering. Could be as simple as digital IO or as complex as serial protocol.
4) Light en
Read more…