Gender
Male
About
Location
Ontario
Please tell us a bit about your UAV interest
Building an Ardu Hex from jDrones.
Hometown:
Ottawa
Activity Feed
I am happy to report that I have achieved a major victory in the battle against the loathed Jello Effect - the asymmetric video motion caused by the high-frequency mechanical vibration. I run a hex setup with a 2-axis gimbal and the GoPro HD Hero 3…
Hi,Could you please recommend a decent gimbal 2 axis stabilization system.I currently use built in Wookong M 2 axis stabilizer but it has substantial lag as the gyros are not installed on the camera mounting plate plane, even with the highest gain…
I am sure I am not the first one facing the dilemma – plastic vs. carbon – when choosing multicopter props. Carbon fiber is twice as expensive. On the other hand, props are the key moving part and may significantly affect your rig’s performance,…
Thought to share in case anyone is interested in Wookong.http://www.youtube.com/watch?v=7h6JuJXhdE8BTW, I am looking for people trying to find a solution for making multicopter props safer by either building protective housing or recommending…
"I am happy to report that I found a solution. The TX (WFT 09) came prepogrammed with the low throtle endpoint of 107%. Once I bumpted it to 120%, recalibrated the APM-radio and finaly recallibrated all ESCs manually, they finally startup as they are…"
"I am having exactly same issue, except only 2 parallel motors twitch and beep rapidly (4 beeps per second). I have tried everything described below and no luck. Please post if you find a solution. "
I have been having tons of issues with the vanilla jDrones ESCs (20A) that came with my hex kit. After calibrating and re-calibrating multiple number of times (manually and automatically), I finally managed to get my hex into the air (it was -15C…
