HC-SR04 Ultrasonic
Hi everyone,
Is it possible user this sensor HC-SR04 Ultrasonic Sensor Distance Measuring Module instead of the actual sensor (MB1000 LV-MaxSonar-EZ0)?
Or use this for object avoidance?
Read more…Alexandre Nascimento's Discussions (11)
Sort by
Drone + NeverWet
Hi,
Has someone used the product "Neverwet" (http://www.neverwet.com/) on a drone?
Would be a good idea?Read more…
EDF
Just for curiosity, is possible to use EDF as the engines to quadricoptero?
like this one
Thanks
Read more…perform individual tests
After a short circuit, which burned 4 ESC, I'm afraid to turn on the equipment again.
Is there any way to turn only part of the equipment and perform individual tests.
Example.
Connect only the APM2 and verify that their outputs are working.
Connect only
Quadcopter Protection
Is it necessary or not? put some protection to avoid injuries from the blades?
If yes any suggestion?
Thanks
or
ESC burnt after installing the module 3dr
After installing the module 3dr, one of my ESC burnt.
It was just coincidence or is there some link with the install of this module?
The control wire of the ESC was close to the 3dr module .
Read more…How flat the quad need be to fly?
How flat the quad need be to fly in good balance?
I cant get the quad to take-off without drifting!
I think the airframe is tuned.
Thanks
This is the video of my take-off
https://www.youtube.com/watch?v=s1QaDZyhRhM
Read more…Sonar not in zero
Hi, my sonar is not in zero, its shows 21cm, and only after this, is lift the arducopter, its starts to change.
its normal?
Read more…ROLL with 3º in a level surface.
My APM2 is geting 3º in Roll in a level surface, is ther any way to zero?
Read more…Can´t connect and can´t fly
All that i can get from de APM2 is this
Init ArduCopter V2.6
Free RAM: 2370
FW Ver: 118
----------------------------------------
load_all took 4448us
Was working fine. Now i can´t fly nither connect.
I´m still able to update the firmware, but that´s all.
An
Read more…