About

Gender

Male


Location

Kassel


Please tell us a bit about your UAV interest

First Quad on its Way !


Hometown:

Kassel


Activity Feed

Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"My Gps reception is excellent too! Again...not the MTK it is the uBlox! might be the better alternative anyway!

The Gps mount is no Solid in total. Only the lower and upper 2 layers are Solid filled. The other layers are at 25% infill.
Adding up…"
Apr 28, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"I meant pcb"
Apr 26, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"Thanks. Had to expand one side a bit to accommodate the hole for the screws. Holes have a 2mm step to get the screw heads level to the upper layer. So they don't short the pub."
Apr 26, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"Fist Try

will continue tomorrow..."
Apr 26, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"That should do it.

Will use the left hole Centered in the middle axis of the Mount as the "pivot" point to get the angle right."
Apr 26, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"Nice schematics ! I can work with that!
2 more questions:

I presume the Connector goes to the right towards APM- right?
All messurements are center hole - center hole ? 3mm hole?

Will check on Postage tomorrow but should not exceed 1,45 € so 2 $…"
Apr 26, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"GPS Mount with hole in the Middle"
Apr 26, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"No! you are fine! No hi-jack! All good!

A CNC is always a nice thing to have! Waiting for mine continues.. :D

Where do you need those Holes? One ?Two? No Problem, just a matter of some klicks..."
Apr 26, 2013
Andreas commented on Andreas's blog post Neo 6 Gps Mount (Crius PCB) - 3D printable .stl file
"Thanks !

As my copter isn't flying yet, i dont have any knowlege about vibrations regarding the GPS receiver.
It was a 5 min Design and a 5 Minute print. But all in all it fits nice without any wobble.

@LTMNO 5$ sounds good! Send me your postal…"
Apr 26, 2013
Andreas replied to u4eake's discussion APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
"Maybe a bit off-topic but might help.

My Blogpost regarding a 3D printable Mount for the Crius PCB.

LINK"
Apr 26, 2013
Andreas posted a blog post
Hello everybody!Like a lot of people here i am building my first quad. To be straight forward it is of the Rctimer Shop.Learning a lot from all of you guys it is now time for me to give something back, although my Copter isn't flying yet :DI…
Apr 26, 2013