Gender
Male
About
Location
Weiz
Please tell us a bit about your UAV interest
Hobby
Hometown:
Weiz
Activity Feed
"Hi,
is the latest development FW (Copter V3.4-dev from March 1, 2016)
compatible with PixRacer?
Or do I have to use the Copter 3.3.4_rc4 pixracer?
regards,
Andreas"
is the latest development FW (Copter V3.4-dev from March 1, 2016)
compatible with PixRacer?
Or do I have to use the Copter 3.3.4_rc4 pixracer?
regards,
Andreas"
"Also it is possible to recharge the lipo after flight and calculate the value of amp/volt by recharged capacity and used capacity displayed in MP.
regards,
Andreas."
regards,
Andreas."
"@ Scott W
Hi,
I have same Problems with parameter saving...
and "forgotten" Parameters after reboot....
You can read here my Posts in german Forum...
FPV Treff
I will translate in english an post it here later...
Regards, Andreas"
Hi,
I have same Problems with parameter saving...
and "forgotten" Parameters after reboot....
You can read here my Posts in german Forum...
FPV Treff
I will translate in english an post it here later...
Regards, Andreas"
"Hi,
I ordered two 3DR modules 433 Mhz with antennas from RCT and due to bad performance I changed this antennas to a 2.4 Ghz one.
In 3DR Config Tool I noticed no difference in RSSI and noise value.
So for further investigatin I made a X-Ray from…"
I ordered two 3DR modules 433 Mhz with antennas from RCT and due to bad performance I changed this antennas to a 2.4 Ghz one.
In 3DR Config Tool I noticed no difference in RSSI and noise value.
So for further investigatin I made a X-Ray from…"
