Gender
Male
About
Location
Los Angeles, CA
Please tell us a bit about your UAV interest
FPV Flying, Cinematography
Hometown:
Los Angeles
Activity Feed
"for attachment, currently there is a servo that is in the center for pitch stabilization, that connects to another piece for bank stab.... not very ideal. all the weight is on the servo's themselves.. hence a big re-design, this was more a proof of…"
"3D view of camera rig... I'll start a new thread once I have more time to continue work on the system."
"coming soon to a multirotor near you.... :)
6x gopro hero3
This was an early prototype, the camera's are now no longer in a portrait orientation, due to rolling shutter.
horizontal configuration, allows pretty seamless stitching, still working out…"
6x gopro hero3
This was an early prototype, the camera's are now no longer in a portrait orientation, due to rolling shutter.
horizontal configuration, allows pretty seamless stitching, still working out…"
"Here's the LED Status holder!
http://www.thingiverse.com/thing:38644"
http://www.thingiverse.com/thing:38644"
"Thanks all! got some more to post soon,
The LED's are for GPS/ARM Status, they are 2 - 10mm RGB LED's that I had laying around connected to the APM on A7 & A6, set LED_MODE = 3 in Mission planner. (note Led's have 100ohm resistor to limit current)…"
The LED's are for GPS/ARM Status, they are 2 - 10mm RGB LED's that I had laying around connected to the APM on A7 & A6, set LED_MODE = 3 in Mission planner. (note Led's have 100ohm resistor to limit current)…"
New to the ArduCopter world, so here goes.. finished my first hex build a few weeks ago, so have been working on a few cosmetic upgrades.. It's a bit silly but I like the little puck gps modules that DJI has, so decided to make and share a similar…
