Gender
Male
About
Please tell us a bit about your UAV interest
Flying uav's in france, fpv and AP
Hometown:
SAINT CLAUD
Activity Feed
"If still available I'll take them"
Hi,I'm trying to configure failsafe on my APM 2.5 and I configured my frsky receiver to go down to 985 (minimum sent by the radio is set to 1015 otherwise when throttle is at 0) on the throttle channel when in failsafe and auto land mode.While bench…
"Ok so I changed the many motors taht were destroyed in the crash and went for another try..
I flew and again after a little more than one minute the x8 litterally turned off like the first time and flipped to the ground.
I've isolated what's causing…"
I flew and again after a little more than one minute the x8 litterally turned off like the first time and flipped to the ground.
I've isolated what's causing…"
"No one knows what I should/could check ? :/"
"Ok, one question then, is it possible that the fact I changed from PPM to PWM caused this in any way ?
Thanks"
Thanks"
"here is what I found looking at the logs. At the moment when the crash happened (when the quad started to bank left and almost upside down until crash) the YAW went crazy up for no reason and followed the altitude curve
ALSO, as said the quad went…"
ALSO, as said the quad went…"
"Ok ! here are the logs of that flight
http://s000.tinyupload.com/?file_id=00462091409339393298
thanks"
http://s000.tinyupload.com/?file_id=00462091409339393298
thanks"
Hi everyoneI had an unexeplained crash with my X8Here are the specs : 530kv motors with 14 inches graupner propsAPM 2.5 with 8 20A escsSo what happened, I was trying my new retractable landing gear on channel 6.I have channel 5 configured as flight…
"Any update on this? I'm trying to do the same thing except I have all the 8 motor outputs used as I'm on an octo"
Hi,I've got an APM 2.5 with the latest x8 firmware.I'm using a ppm receiver. I'd like to control a servo from one of the auxiliary output with a PWM signal.Is it possible to do this (map one of the ppm inputs to a pwm output on the apm?)ThanksAntoine
