I have a 3Drobotics Y6 with pixhawk. I am turning my Y6 into X8. My problem is that i am not sure what PDB to use. On 3Dr website i cant buy the Octa PDB that comes with the X8.I could use two 3DR Quad PDBs and i would have to connect their power inp
Read more…I have couple drones but now i am planing to build a heavy lift multi rotor.Looking for advice what to use, number of motors, types of motors, blades, battery. Trying to figure out the optimal power/ weight ratio with the today available equipment.Ma
Read more…I have a pair of Fatshark Attitude v2 goggles with Trinity Head tracking. I set up my camera gimbal and it works fine on the default ch5/6. I am getting conflict on ch5 so i would like to set my goggles to use ch7/8 instead, but i dont understand the
Read more…I have a 2 axis brushless gimbal controller that i wast to use on a gimbal setup to control and stabilise Yaw and Pitch instead of Pitch and Roll. Any ideas how to do that?Also is there any controll board that translates the RX input to Brushless Gim
Read more…I am trying to install hexTronik MinimOSD between Fatshark and Pixhawk. I know i am getting signal if there is no OSD connected inbetween. If I follow the instructions on the first picture (found on this page: http://copter.ardupilot.com/wiki/common-
Read more…Check out these cool Drone related T-Shirts. Drone Evolution, Warning, I do all my own stunts and every propeller diagram layouts, even for rovers and helicopters. You can customize them too and pick your favorite color and style.
Read more…I have a 3Drobotics Y6 copter with Pixhawk.
I am relatively newbie to quads. This is my first big drone.
I am done with assembling the hardware and while calibrating the hardware in Mission Planer 1.2.93 i encountered issues with Radio Calibration. Eve
Read more…