"About the reset button....
Do you see the prograssbar when updating?
If you dont have a full cable connected you need to press reset on both charset and
firmware upload. If you can upload firmware without pressing reset, you should be able to
"eh, maybe if it had a plan to go somewhere on its own :) dont think it knew i put rocks on its feet, haha
Maybe if there was a mission and it should reach a certain height, but not in stab mode, i cant imagine...
You mean you couldnt take off?"
"Dont know if this belong here....i have this hex with rc5. Almost tried all 3.3 rc's, but hasnt done much flying. Just waiting for release.
Anyway, today i was trying to calibrate a attopilot and locked the hex down to prevent lift. In stabilize…"
"ok with that cable you shouldnt have to press the reset button. And you have the rx to tx and viceversa? If that doesnt work then maybe you have to update the bootloader. Its been along time since i did it, and forgot the procedure.
"no it was not :) If you dont have a ftdi that can connect to the dtr/grn pin, you have to press the reset button on the osd right after pressing connect in the software. So, press connect, and then press press and release the reset button. might…"
"A character firmware (older one) is actually included in r800, its in the FW & Char folder called Character_Updater_FW.hex. No need to search for older one to use. Can be diffucult to know how old it has to be to be working too.
I think it was size…"