About

Gender

Male


Location

Calgary, Alberta


About Me:

PhD Electrical Engineer, RC Hobbier


Please tell us a bit about your UAV interest

Agriculture traceability, Asset Management, Research


Hometown:

Calgary


Activity Feed

Bob Davies posted a discussion in ArduCopter User Group
I set the channel 7 config in MP to turn the sonar on and off. When I test the sonar from the command line test it shows the distance no matter how the channel 7 switch is set. How can I be sure that the sonar is being turned on or off in flight.…
Mar 28, 2013
Bob Davies replied to Dave C's discussion Arducopter Tuning Guide
"Thanks for this detailed explanation of roll adjust. For pitch do you use the same test fixture? What about for YAW? Thanks."
Mar 19, 2013
Bob Davies replied to Hugues's discussion Thanks "3DR propeller's mounting system" for a... CRASH in ArduCopter User Group
"I've used the collets alot and even with a bad crash I never had problems. You have to make sure that the collet 'takes' when you tighten them. I always check with a magnifier to see that the collet is fully compressed around the engine shaft and I…"
Feb 25, 2013
Bob Davies replied to Greg McHugh's discussion APM 2.5+ top vs side entry on quadcopter in ArduCopter User Group
"Side entry is better. Esc and receiver cables are easier to manage."
Feb 25, 2013
Bob Davies posted a discussion in ArduCopter User Group
HiI'm not sure how the on board compass setup is supposed to work on a hex. I connect via 915 M link and every thing looks good except the direction on the flight data screen is always out by alot like 180 degrees. Everything flies good in manual…
Feb 2, 2013
Bob Davies replied to Bob Davies's discussion APM2.5 won't connect to mission planner with RC receiver attached
"I found that the USB voltage would drop too low with the receiver attached, likewise with the 3dr link. I think that I also saw this when I used esc power so I got a programmable bec and set it for 5.1 v. That fixed it."
Jan 29, 2013
Bob Davies posted a discussion
Would anyone be able to comment on why I can't get the Mission planner to connect to my APM 2.5 board with the RC Receiver attached. I can connect by usb and 3dr radio link without the receiver attached, Thanks.
Nov 13, 2012