Gender
Male
About
Location
Clementi
About Me:
interesting in Copter development
Please tell us a bit about your UAV interest
formation flight application
Hometown:
Taiwan
Activity Feed
"i use gps inject function on mission planner, it can receiver RTCM from base(M8P) as image below, also i have setup px4 gps_inject parameter (send to all), it's seem nothing have been send by gps_inject function
NEO-M8P-2 (base) …"
NEO-M8P-2 (base) …"
"i use gps inject function on mission planner, it can receiver RTCM from base(M8P) as image below, also i have setup px4 gps_inject parameter (send to all), it's seem nothing have been send by gps_inject function
NEO-M8P-2 (base) …"
NEO-M8P-2 (base) …"
"i use gps inject function on mission planner, it can receiver RTCM from base(M8P) as image below, also i have setup px4 gps_inject parameter (send to all), it's seem nothing have been send by gps_inject function
NEO-M8P-2 (base) …"
NEO-M8P-2 (base) …"
HiIn order to avoid GPS drift, I change GNSS to rtk, it can provide position correctly in ±1cm.although the ardupilot can receiver accurate position information,drone still have flight drift in loiter mode ,the range around 45 cm.【Video here!!!】as i…
i upload firmware to AC 3.3.2, when i connected to Mission Planner, MP shown the message as image, i have no idea about this, does anyone have same issue?thanks
