About

Please tell us a bit about your UAV interest

F550 with Pixhawk


Hometown:

Austin


Activity Feed

Chris replied to Chris's discussion Pixhawk setup problems - can't throttle up ESCs
"Ali, your video shows exactly the same problem that I had. In the end, I started from scratch and reloaded the firmware. However, I had to load different firmware to get it to reset. By that I mean I had to load quad firmware on to my hexacopter,…"
Aug 11, 2014
Chris replied to RoboBill's discussion Needing do_set_servo command on a Pixhawk rover help in ArduRover User Group
"WARNING! Maximum waypoints is 127. Any more and you will have to completely reset and recalibrate your PIXHAWK. Learned that twice the hard way. How do I formally request more waypoints to the development team?

I'm getting closer. However, on power…"
Jul 20, 2014
Chris replied to RoboBill's discussion Needing do_set_servo command on a Pixhawk rover help in ArduRover User Group
"For anyone that is really good at multiple DO_SET_SERVO commands, and delays between those commands without moving to a new WAYPOINT in between, please read the BACKGROUND below followed by the QUESTION.

BACKGROUND
Thanks Bill, that is funny... I…"
Jul 20, 2014
Chris replied to RoboBill's discussion Needing do_set_servo command on a Pixhawk rover help in ArduRover User Group
"Hello Bill, were you able to resolve this issue? I have the very same problem.

I have a Pixhawk with 2 servos connected to pin 50 and 51. Power to the servos is coming from the +/- pins associated with pin 50. I set the following commands in my…"
Jul 19, 2014
Chris posted a discussion
Hello, I have 2 drones.. both DJI F550. Drone #1 uses Naza Lite controller and works great!My second drone is controlled by a Pixhawk.PixhawkOPTO 30A ESCDJI 2212 motors4S batterySpectrum DX9 transmitterSpectrum AR8000 receiver3DR PPM EncoderProblem…
Jun 8, 2014