Soquel, CA

About Me:

Just short of finishing a Mechanical Engineering Degree, and I have been building things since I can remember.

Please tell us a bit about your UAV interest

I have had a interest in UAVs since they we just starting, but I never got around to building one. My senior project is a autonomous quad-copter with some additional features.



Activity Feed

Chris Fulmer commented on Gabe's blog post Autonomous gas powered heavy lift quadcopter we are calling HLQ
This is the first to my knowledge.  Some have made nitro powered variable pitch quad that fly.  The problem is that most of them use RC helicopter tail rotors and booms that are not made to handle the power through put that is needed.  They…"
Jul 1, 2013
Chris Fulmer commented on Paul Mather's blog post 6 position mode switch for APM - Around $16 total
"First thank you for this post.  I did this on a cheap 6ch HK-T6A controller, but I had to mess with the resistors a little.  One was kind of close( about 10 from the edge of that mode range), but it was stable.  Here is what I had:…"
Feb 18, 2013
Chris Fulmer replied to Dromedary's discussion APM2 + MP: 'COM 3' does not exist
"I had the same issue, but it was a new install.  I had to install one additional driver "Arduino MEGA 2560.inf".  There is also this topic http://diydrones.com/forum/topics/com-port-doesn-t-existed-error?co... that people have downgraded the version…"
Dec 31, 2012
Chris Fulmer replied to GARY MCDONOGH's discussion apm 2.5 com port set up
"I had this issue and had to install one additional driver.  "Arduino MEGA 2560.inf" Then everything started working.

Dec 31, 2012