About

Gender

Male


Location

Duluth, GA


Please tell us a bit about your UAV interest

just for fun


Hometown:

Johns Creek, GA


Activity Feed

Curtis replied to John Maugeri's discussion CLI Giving Garbage with APM 2.6 with 3.2 firmware
"to add to this... I hit enter 3 times.. and the data just keeps coming...  it will not stop unless I disconnect."
Dec 7, 2014
Curtis replied to John Maugeri's discussion CLI Giving Garbage with APM 2.6 with 3.2 firmware
"they were two different topics... and I DID search
and NOONE asked me to add it to my first post.

So...  if there is no more CLI..  how does one erase the EEPROM???"
Dec 7, 2014
Curtis replied to John Maugeri's discussion CLI Giving Garbage with APM 2.6 with 3.2 firmware
"here is a screen shot...   click on terminal and all I get is junk....mp.jpg"
Dec 6, 2014
Curtis replied to John Maugeri's discussion CLI Giving Garbage with APM 2.6 with 3.2 firmware
"I have the same issue.. posted a thread with a screen shot but the mods deleted it.  Trying again..ie: cycling the power does nothing"
Dec 6, 2014
Curtis replied to Curtis's discussion I guess this goes here..... can't get APM 2.6 to come to life
"here is something.....  not sure if it means anything or not....
on the flight data screen...
on the status tab...
I noticed that all the CH#IN status show the calibrated PWM from the radio...
but the CH#Out for all the channels reads 1014 and…"
Dec 6, 2014
Curtis replied to Curtis's discussion I guess this goes here..... can't get APM 2.6 to come to life
"Thanks. Tried several different batteries.  Voltage good... made sure the battery cuttoff was low.. and tried with disabled...
also..  I did what you mentioned as well.  First tone.. drop throttle... get confirm from ESC's and cell count beeps...…"
Dec 6, 2014
Curtis posted a discussion
SetupTorque 930 motorsAirboss 35A ESC'sAPM2.6 controllerFutaba RXFutaba MZ TxOk...at my wits end...working on this for two days..... firmware loaded(APM 2.6...latest stable firmware) (several times) everything calibrated (several times) sorry... no…
Dec 5, 2014