"OK, I think I have it working. I went back and checked both radios and the Net ID had changed. When I hit Copy Required To Remote and then Save, it seems to have fixed it.
Thanks"
"I think I have both radios on the same Net ID. I am not sure what you mean by OTG Cable. I have the USB cable and the 3DR antenna plugged into my phone. To see the settings in the antenna I plugged it into Mission Planner and loaded the settings. I…"
I am trying to set up the Eachine Racer 250 with a FS Th9X transmitter using a FrSky D4R-II 4 channel receiver. This is the setup that I use for my 3DR Iris+ and I would like to be able to use the same transmitter for both. Is this combination…
I have a Iris+ with the FS TH9X Transmitter.Does anyone know of a way to backup the settings of the transmitter?I looked at the Smartieparts.com board, but they tell me I would have to flash and upgrade my firmware and I don't want to loose my…
I have a Iris+ and another one for parts. I am looking for a FPV racer that I can use my FS Th9x Controller and the receiver out of my spare Iris in.Does anyone have any ideas if there is a racer that will work?Thanks
I am using a Iris+ with the Tower App.Is there anything that tells what each of the parameters is?I would like to set a default speed for waypoints instead of setting each waypoint speed individually.
"Thanks, I just activated ch8 on my FSTH9X transmitter and set Ch 7 to Brake and Ch8 to Motor Emergency Shutoff. If I upgrade my firmware will I loose these settings?
Also do you know how I can save all of my setting in the transmitter to a backup…"
I am using Mission Planner with Arducopter 3.2.1 on a Iris+. I keep looking at upgrading to the latest version. I like some of the new features like BRAKE, but don't want to mess up anything that I have now.Is 3.3.3 stable?Is there a list of changes…
I have a Iris+ with the Iris+ FS-TH9X controller.I found one of my switches was broken today. Does anyone know where I can buy a replacement switch?If your looking at the controller it is Top Left Rear switch. It is a spring loaded switch and not a…
I have a Blade 350QX2. I just replaced the main board and compass because it got shorted out. I have installed the new board and was Calibrating everything. I was having trouble getting anything to calibrate. I re-installed firmware 2 and…
I have a LI-24 Lipo/LiFe Chargerhttp://www.rcplanet.com/DuraTrax_Li_24_2S_4S_LiPo_LiFe_AC_Balancing_Charge_p/dtxp4620.htmand 3 Zippy 1000 20C Series 2 Cell 7.4 volts batteries which were bought to use on FPV…
We have a Blade 350 qx2 and we had the body off of it. Now when we try and power it up we get a yellow blinking light with a flat sounding tone. The red and blue light blink on the main board and then the blue light goes out and the red light stays…