"Hi JB,
Jurgen sent me the photo the other day.
The photo above is a composite of 4 boards, Motherboard, Mini Pixhawk, Edison and TX1 Carrier Board.
If you want any more information you can email me
ds@auvidea.com"
"Auvidea are working on a Mini Pixhawk Module and Edison Module which fit on a Mini Motherboard
This was based on the Pixhawk 2 Design. Mentioned Here.
Also A Modular Mother board to take Mini Pixhawk Module, Edison Module and a NVIDIA TX1 Carrier…"
"Hi Alex,
you can email Jurgen js@auvidea.com or email me ds@auvidea.com
we have the PCBs being made now for the TX1 Lite Carrier board and hope to have the first batch made up soon.
you can see our UAV products on our website; http://www.auvidea.eu/…"
"http://www.adafruit.com/datasheets/PCA9685.pdf
here is the datasheet for the adafruit PCA9685 board.
Afaik you set all channels to same frequency, so the aux outputs 9-24 should be able to be set to 50hz.
Compatability with PI Zero is something we…"
"Hi Rob,
I am looking to build a trad-heli,
Now i see your new release i would like to try it out.
I scanned the documentation and see a TREX 450 is suggested and i see on forum goblin 380 is mentioned
what are your suggestions for a first electic…"
"I have tried to post twice and been denied on drones-discuss, I wanted to clarify the CAN driver, Pavel in UAVESC Group has said it runs on linux and raspberry pi'
I have a Zubax CAN GPS it runs on Pixhawk with an old CAN driver on APM and newer…"
"I have tried 3.4 dev (master) and i have problems with compass calibration on Raspilot v1.1
i have a external compass connected as well as the internal (s).
Anyone else using Raspilot ?"
"sorry if its a bit off topic.. I have a Raspilot V1.1
I wish to start developing code, A basic question, I have followed the documentation to set up windows and linux I found a few places where the documentation was outdated, it was when i got to…"