About

Gender

Male


Please tell us a bit about your UAV interest

Multirotors


Hometown:

Kaliningrad


Activity Feed

Evgeniy Spaels commented on Adrián Nagy Hinst's blog post GimBALL - 3D printed DIY Gimbal with closed hull - PART1 (design)
"For printed gimbal the temperature is critical parameter"
Nov 25, 2014
Evgeniy Spaels commented on Adrián Nagy Hinst's blog post GimBALL - 3D printed DIY Gimbal with closed hull - PART1 (design)
"Daniel, I not test  GB36 it is heavy for me and without hollow shaft. If rewind 2804 it will be better. But my choice is iPower GBM2208H low weight, more power then 2804, hollow shuft, stay warm after hours indoor operation at 160 power value.
 "
Nov 25, 2014
Evgeniy Spaels commented on Adrián Nagy Hinst's blog post GimBALL - 3D printed DIY Gimbal with closed hull - PART1 (design)
"I make a lot experimented with 3d Printed gimbal and these motors especially with RCTimer 2804 it is a bull shit, it is only good on pitch. Design of gimbal is good but my opinion it's overshooting."
Nov 25, 2014